间隙的例句（间隙在句子中的用法）

• The sun appeared through a rift in the clouds. 太阳从云层间隙中冒出来。
• We had a talk between takes. 在拍摄镜头的间隙, 我们谈了一次话。
• Secondary interstices develop after the rock is formed. 在岩石形成以后再发展次生间隙.
• In the larger interstices, this fluid has the ability to limit circulation. 在较大的间隙内, 此液体有限制流通的性能.
• It is because of the big clearance between the brake facings? 是不是因为刹车片之间的间隙太大了?
• Please leave a space between the lines for the necessary corrections. 在行与行之间要留出间隙,以便作必要的修改.
• The bridge and the top of the bus was only ten clearances. 桥与公共汽车车顶之间的间隙只有十厘米.
• Theatre lobbies were filled with a vociferous crowd during the intermission. 剧场大厅放映间隙,人群中发出喧闹的嘈杂声.
• B , Interval between top sheet and drapes covered by sterile pillowcases. 上单与底单间隙用无菌枕套覆盖.
• B, Interval between top sheet and foundation drapes covered by sterile pillowcases. B上单与底单间隙用无菌枕套覆盖.
• Up to then, they'd merrily bashed out albums in between tours. 那时，他们已经利用巡演的间隙轻松炮制了多张专辑。
• Objective To evaluate the relationships between retromammary space and complications augmentation mammaplasty with injection. 目的探讨乳腺后间隙与注射式隆乳并发症的关系.
• Recheck clearance on all valves again after locknut is tightened. 防松螺母拧紧后,再对所有气门的间隙重新检查一次.
• Recheck clearance again after tightening locknut . Readjust clearance as necessary. 拧紧防松螺母后,再一次检查间隙,视需要重新调节间隙.
• The energy band gaps of sputtered Cr 03 are approximately 1 . leV ( AD ) and 1 . 4 eV ( HT ). 其中第三种溅射铬-氧薄膜(C_ rO3)的能带间隙约 1.leV ( A-D ) 和1.4eV ( H-T ).
• This paper presents a 3 - D model for double - gap open cavity of S - band relativistic klystron amplifier. 建立了S波段相对论速调管放大器双间隙输出腔开放腔的3 维 模型.
• The ionized particles then flow past a set of closely spaced metal plates. 然后,被离子化的粒子流过一组间隙很小的金属板.
• Please note there is 1 - 1.5 mm interspace of each piece to adjust. 注意每块间预留1-1.5毫米间隙以便微调作品.
• The interelectrode gap could be controlled only within several to several ten microns using this system. 该系统能够将加工间隙控制到几微米到几十微米的范围内.
• Firstly, the relation between 6 - dimision forces received by cathode from electrolyte and interelectrode gap is researched. 首先研究六维力与加工间隙之间的关系.