temperature的例句（temperature在句子中的用法）

• Curing shrinkage, temperature and curing enthalpy of benzoxazine based on diphenyl oxide resin were investigated. 研究了苯并口恶嗪二苯醚树脂固化时的体积收缩率 、 固化温度和固化焓变等.
• If more bentonite clay is used, the lead temperature must be decreased. 如果多用膨润土, 铅的温度必须降低.
• The full - graphics , backlit LCD simultaneously displays set point and actual fluid temperature. 高清晰有背光照明的液晶显示屏可以显示所设定的温度和流体的实际温度.
• Dewaxing with over - temperature autoclave, overpressure alarm function. 脱蜡釜设有超温 、 超压报警功能.
• The effects of austenitizing temperature on mechanical properties of austmepered ductile iron ( ADI ) were researched. 研究了奥氏体化温度对 ADI 力学性能的影响.
• The influence of chemical composition on austenitizing temperature was introduced. 介绍化学成分对奥氏体化温度的影响.
• Arsine is a toxic, colorless gas with a garlic - like odor at room temperature and atmospheric pressure. 胂是一种无色有毒气体,在室温和大气压力下会发出类似大蒜的气味.
• The synthesis of ν - curcumene was described. The experiment affirmed that ν - curcumene can aromatize to α - curcumene readily at room temperature. 用金属锂 - 液氨一步还原法合成γ姜黄烯.实验证实γ姜黄烯极不稳定,室温下极易芳香化转变成α姜黄烯.
• Saturation and aromatics affect the ductility of asphalt at low temperature. 饱和烃和芳香烃影响沥青的低温延度和粘结性.
• Special formula for the rubber wheel, antifriction, aging resistance and high temperature resistance. 专用橡胶轮系独家专用配方, 耐磨损 、 耐老化、抗高温.
• The temperature dependence of exchange bias and coercivity ferromagnetic layer and antiferromagnetic gain layer is discussed. 讨论了铁磁反铁磁双层膜中交换偏置和矫顽场随温度变化的关系.
• Anthocyanidin synthesis needs proper temperature and oxygen, which will fail at low temperature or deficient oxygen. 花色素的合成需要适宜的温度和充足的氧气, 低温或缺氧不利于花色素的合成.
• The suitable recovery strain annealing temperature was 500 ℃. 适宜的回复应变退火温度为500℃.
• Aneroid readings must be adjusted for temperature and humidity. 空盒气压计读数亦须作温度改正和湿度改正.
• The voltage may provides an analog representation of the temperature difference. 电压可以成为温差的模拟表示.
• Ammoniacal synthesis procedure has some dangerous characteristics, for example: temperature, press , flammability, explosive and so on. 合成氨生产工艺具有高温 、 高压 、 易燃 、 易爆的特点, 对工艺控制的实时性要求极高.
• Treatment of 3 - aminopyridine with AFA at room temperature gave 3 - formamidopyridine in 95 % yield. 在室温下 3- 氨基吡啶与甲乙混酸酐反应制得3-酰胺基吡啶,产率为95%.
• Another ambient temperature sensor is the vapor - filled bellows. 另一种空气温度传感器是充气波纹管.
• The agglomeration and sintering of fine particles can necessitate a lowering in temperature of operation. 由于微粒易于聚集和烧结,不得不降低操作温度.
• The different influences of temperature to two aeroelastic systems are analyzed. 分析了温度对这两种热结构气动弹性系统的不同影响.